SDR Trunk Conventional Stream

[jeepsandradios]

Running into issues with SDR Trunk and streaming. I find mixed information but I was under the impression we can now stream conventional via SDR Trunk. I have 4 channels working in SDR trunk. Can hear on my speaker of the PC but do not seem to make it to the stream. In SDR Trunk Streaming tab I have a enabled feed "Broadcastify Feed" that shows connected. Ive done multiple tests and broadcastify shows it connected but I dont ever hear audio on broadcastify. I did find stuff about alais list and I use an alias list for those frequencies although I only have a few MDC IDs in it. I did select the alias list in SDR as well for the streaming tab. I dont see any streaming check boxes in the individual channels.

I really dont want to waste a scanner for this as my pi crashed a few years ago.

 

[jeepsandradios]

Ok Think I got this figured out now. Found another post about setting talkgroup range. I didn't think that would fix my issue but 1-65535 was set and now I have audio on my feed.

 

[dave3825]

It’s it just one freq and works with a tg range, you can probably leave it like that, but if multiple conventional freqs, pretty sure a unique tg for each one would be required.

 

[jeepsandradios]

Well so far I have audio on all conventional with a single alias list so I'll see how it goes.

 

[jeepsandradios]

So I lost power yesterday and lost everythign in SDRTRunk. All channels streaming info and all. I set it all back up the way it was but dont seem to get audio on my feed again. I have 2 channels and can hear audio and see audio on the channel. But nothign to stream. Each has its own individual alias with talkgroup range 1-65535. Whe I set this up all worked well once I added the talkgroup range and has been solid until power yesterday. I did add a UPS so it wont drop but can't get any audio accross the stream.

 

[dave3825]

So I lost power yesterday and lost everythign in SDRTRunk. All channels streaming info and all. I set it all back up the way it was but dont seem to get audio on my feed again.

Is SDRT receiving the calls? And just not passing audio?

 

[jeepsandradios]

Yes SDRT is receiving fine. It appears to have started working randomly overnight as I went to mess with it today and I have audio on the broadcastify. I guess I need to backup folders as well. Iver never lost everythign from SDR trunk on many power changes reboots etc.

 

[mtindor]

So I lost power yesterday and lost everythign in SDRTRunk. All channels streaming info and all. I set it all back up the way it was but dont seem to get audio on my feed again. I have 2 channels and can hear audio and see audio on the channel. But nothign to stream. Each has its own individual alias with talkgroup range 1-65535. Whe I set this up all worked well once I added the talkgroup range and has been solid until power yesterday. I did add a UPS so it wont drop but can't get any audio accross the stream.

An RR Stream? An RR calls feed? For conventional, you assign a fake TGID, but they need to start at 1 and go up. If you have four freqs, the TGs I think need to be 1-4. If you look at the commandline window associated with SDRTRunk, it'll likely tell you what is going on. I had a similar issue the other day and the CLI window showed [1 No-Freq-Table-Entry-For-Upload]. That was because my single conventional freq was set with a take TG of 100. I changed it to 1 and it worked fine. Now, I wasn't sending conventional P25 but rather a regular NBFM paging freq. So maybe it works different with P25 conventional, and what I've said may have no bearing. But do check the CLI