SDS 200 STARTUP KEYS

Status
Not open for further replies.

medic9351301

Member
Banned
Joined
Aug 16, 2002
Messages
1,669
Hello, I would like to know how many start up keys you can use for the sds 200. according to the manual its 9 but in sential it goes to 99 .
I have a state system I monitor that is broken down by counties . All using the start up keys 0-9 .
here is the break down
s0 -city fire
s1 -couny fire
s2- county sheriff
s3 -county law
s4- mutual aid /inter op
s5- shell county all - pelham
s6- shel county all - signal
s7-blount county-all
s8- cal couty-all
s9-tall county -all

so my question is can i add another depart with a start up key of 10 or have i used all of the start up keys
 
Last edited by a moderator:

hiegtx

Mentor
Premium Subscriber
Joined
May 8, 2004
Messages
11,431
Location
Dallas, TX
okie dokie then thanks
You're apparently confusing "Start Up keys" with "Quick Keys". As Dave has noted, you can use 0-99 for Quick keys, but only 0 thru 9 are valid for startups.

I generally do not use Start Up keys. If you do use them, then whatever Start Up key you use when booting the scanner up is the only Favorites list that is active. While you can reboot the scanner & use a different Start Up key to choose a different list, there is no key sequence that can reset all of them back to On when powering up the scanner. It defaults back to the last Start Up key used. To disregard the Start key selection, & enable one or more of your other lists, you'd have to do that manually through the scanners menu.

But if you used Quick Keys instead, the Quick Keys will let you re-enable any of the other lists, in addition to the one currently active.
 
Status
Not open for further replies.
Top