SDS150: SDS150 Tone-Outs

[dhalbasch]

I am wanting to add some tone-outs to monitor for CDF in Ca. They use two tone as well as what is a D7318 format.
I understand the two-tone, sentinel software won't accept the D7318. Anything I can do to get it to alert?

Thanks in advance,
Dennis

 

[n3obl]

You have to monitor over the air and capture the tone freq. However you do realize that by using this feature you literally have a very expensive minitor that can not scan other channels at the same time.

This feature is the worst feature on a scanner. I didn't by a scanner to be a fancy tone alert receiver.

 

[Chris0516]

You have to monitor over the air and capture the tone freq. However you do realize that by using this feature you literally have a very expensive minitor that can not scan other channels at the same time.

This feature is the worst feature on a scanner. I didn't by a scanner to be a fancy tone alert receiver.

While I have the SDS100 and, won't be getting the SDS150. I also did not get my SDS100(and BCD436HP) for tone-outs.

 

[Eng74]

The only plus to using the *36HP/SDS for tone out is they have 20 channels and not the 10 like 396/996/15 family of scanners. You might be better off using a 15X or one of the new 160DN or 260DN.

 

[buddrousa]

Just remember the more scanners you have the more you hear.
I have Scanners Setup just for Law Enforcement Fire EMS State Systems Different Counties Different States ect.