wasn't there a fix for this from uniden?
If you are speaking of the RTC repair campaign that was in place for the BCDx36HP models... No, there was never a similar campaign issued for the Home Patrol units, and there have only been very scattered reports of those actual RTC problems with the Home Patrol units.
There were firmware updates for the BCDx36HP models just before the start of that repair campaign to let the boot process continue after a short time so that the user wouldn't have to manually enter the time each time the scanner booted up. There was never such a firmware update issued for the HP2, in fact there have never been any firmware updates for the HP2 since it's release. The current versions are the same as the release versions:
1.05 / 1.02 (Main / Sub).
Hopefully, post #3 will take care of the problem. Perhaps the OP will let us know if it fixes his issue.