TRX-1 Stand

Gymbag

Member
Premium Subscriber
Joined
Dec 12, 2004
Messages
257
Location
Oxford County
Just wondering if anyone knows about a stand for the TRX-1. What is everyone using as a stand????? And please don't say a TRX-2 lol
 

RDGDigital

Member
Joined
Mar 27, 2012
Messages
390
Location
MD - Eastern Shore
This thread has some suggestions:


Personally, I use the SpectrumForce Desk Mount (One Scanner, Two Scanners, Three Scanners)
 

TailGator911

KF4ANC
Premium Subscriber
Joined
Feb 12, 2005
Messages
2,344
Location
Fairborn, OH
I second that motion for the Spectrum Force stands. I have 2 of them and they are nice and sturdy. A bit more of a footpriint on the desk, tho. I also have a stand I got from Nifty Accessories that is very nice, built like a tank. As documented here in another thread, some folks are making their own stands now with 3d printers. Lots of options out there.
 

K9DAK

Member
Feed Provider
Joined
Dec 16, 2010
Messages
504
Location
Wauconda, IL
Take a piece of 1/16" aluminum sheet, cut and bend as necessary to fit using the belt clip, screw it to a 3"x4" piece of 3/8" plywood... 20 minutes, and boom... a scanner stand. In my case zero cost since I had all that stuff lying around... made it for my PRO-51, but the concept is the same.
 

TailGator911

KF4ANC
Premium Subscriber
Joined
Feb 12, 2005
Messages
2,344
Location
Fairborn, OH
I remember a guy from the Dayton Hamfest who made wood stands with green or red felt on them, and he made them from pine and used a torch to bring the grain out in them and stained them to a real handsome finish. He had run out at the show and he gave me his card and I tried to call him a few months later but his phone was turned off. The website was defunct, too. That's too bad because I would have bought several, as they were a good compliment to my pinewood desk, the finish was a very close match. They were very nice stands.
 

visegrip72

Member
Joined
Dec 19, 2002
Messages
135
Location
Lake Worth, Fl
I actually have an old computer mouse holder that you would put on the side of an old CRT sitting one the side of my desk's hutch. I then have the belt clip on it holding it up. I had one clip break on my PSR500, but it works nice. The cup for the mouse has other garbage in it.
 
Top