SDS100/SDS200: USDS100 - Waterfall Upgrade

[VK3YMML]

Firmware
Main Version: 1.11.00
Sub Version: 1.02.01

Hi all,

I am based in Melbourne, Australia. Today I downloaded the new edition of Sentinel software for the USDS100, I have updated to the latest firmware. After power-cycling the scanner as instructed by Sentinel I then checked the UPGRADE are on the scanner though I cannot see an option for the "Waterfall" update

I went via the Uniden website and enter the Serial and checksum which is successful - the little notation states that Waterfall is only available for USDS100 - I purchased the upgrade and have the "Key" where to from here.

I have emailed Uniden however any assistance would be appreciated

 

[Enforcer52]

I followed these instructions to install waterfall key.

https://www.uniden.info/download/ompdf/SDS200Waterfallom.pdf

 

[VK3YMML]

I followed these instructions to install waterfall key.

https://www.uniden.info/download/ompdf/SDS200Waterfallom.pdf

This does not work. my version is a "USDS100" not a SDS100 ... I am wondering if there are any other Australian users having the same problem

 

[VK3YMML]

Problem Fixed
Download the latest firmware off the Uniden site. Unzip and copy it to the "Firmware" folder on the scanner.
Use windows to disconnect the scanner and then power cycle insert the Key from Uniden for the Waterfall Upgrade ... works a charm