cable

I am putting up a new Diamond Discone antenna with a 16 port powered splitter (Multi-Coupler) from Digital Loggers. The antenna run is LMR-400 with Type N Connectors. The length is 100' total. From the multicoupler I am trying to decide what cable to run. Each cable from the Multi-Coupler is...

Hi, I recently purchased a used Pro95 scanner and programming cable (catalog #20-048). When the cable is inserted, the screen switches to clone mode, as expected. However, when I attempt to transfer data using Win95, the transfer always fails and says "expected to read back the data we just...

Hello all, I just bought my first Kenwood today (and, in general, my first "professional" two-way radio) and was interested in programming some frequencies into it to listen to. From what I have gathered so far, I believe I need a KPG-22 cable (correct me if I'm wrong) to connect the handheld...

RadioReference Community, Quick Question regarding Cloning a Pro 96 to another Pro 96 I've read on a forum here that someone else used a basic stereo to stereo jack. To do this. Is that possible? I don't need a special programming cable or something? ... I have the stereo to stereo one that...

Hi all, Spectra Plus and im wondering what programming cable will work? I found a cable model number HKN6121A but im unsure if it will work? Thanks, Alex

Would appreciate any insights from the group re. whether the CDM1250 programming protocols support use of only GND and BUS+ for read/write (not flashing.) I want to program via the rear accessory connector (have a remote head setup and the cable doesn't work via the remote head...perhaps because...

I need help on building a usb cable for my pro 164 scanner. if someone can send me a pinout of the stereo plug corresponding to the USB data pins (+5v, data+, data-, -5v) i would greatly appreciate it. I refuse to pay $30 for something that should cost only $10 because radioshack is greedy...

Hi, Running Win500 and using a Prolific USB to serial converter, I have connected things like this: USB to Prolific with a DB9 connector >> Pin2 to tip of a 1/8" plug, Pin3 to middle (ring) terminal, Pin5 (signal ground) to sleve terminal. I've reversed Pins 2 and 3 to test, but no success...

Hello everyone, First of all I know this is probably a really stupid idea but I'm just trying to consider all my potential options. I have a very long cable run from my Scantenna ST-2 to my 3 scanners that I run, total run of about 240'. I'm using tri-shielded RG6 direct burial from the tower...

Hello all, I'm at a stand still on my scanner setup and I'm not sure what I need or should do to get things working at their peak again. I live in a crappy physical location (in a hole) about 7 miles from town, but I have a hill behind my house that I have erected a ~60' tower with a scantenna...

I got a vertex vx-800 and the CE31 software, I want to know what kind of cable i need. I only have one laptop as of now. which is a HP pavilion entertainment notebook running on vista. I need to know what kind of cable I need. Which cable is recomended? A USB programming cable or a serial...

Ok, I'm a total newbie when it comes to "other than stock telescopic antenna" scanning. Other than that I've been scanning for over 20 years. I've just now gained an interest in installing a Discone in my attic, however I have questions regarding the ohm ratings of cable. I've come to the...

I'm trying to use a 20-047 cable with my Pro-96 to upload data from a Vista machine. I'm using Win96 to program it. I was able to download from the scanner to the computer, but I cannot upload from Win96 to the scanner. I have the correct port selected (COM4). I'm not using the 3-inch mono...