I am attempting to program a MOT Type II Smartzone Site on a 796d and experiencing problems.
Here is what I have done so far…
I did a full reset on the 796d (2,9 and Manual buttons). I then installed the upgraded firmware. I am a RR member so I fired up the ARC250 software and downloaded to Bank 1 the site freqs., TGid’s, and trunk settings as the site has been rebanded. I attempted to scan but no luck. The download includes the 4 control channels but it hangs on one freq. and just does an ID Scan and does not lock on any TG.
I believe if you download the site from RR it includes the band plan settings for the reband, is this correct?
Site attempting to load - Upper Maryland Eastern Shore Consortium Trunking System, Upper Shore, Maryland - Scanner Frequencies Maryland UMESC
Everything looks right but I must be missing something.
Thanks in advance for the help.
Here is what I have done so far…
I did a full reset on the 796d (2,9 and Manual buttons). I then installed the upgraded firmware. I am a RR member so I fired up the ARC250 software and downloaded to Bank 1 the site freqs., TGid’s, and trunk settings as the site has been rebanded. I attempted to scan but no luck. The download includes the 4 control channels but it hangs on one freq. and just does an ID Scan and does not lock on any TG.
I believe if you download the site from RR it includes the band plan settings for the reband, is this correct?
Site attempting to load - Upper Maryland Eastern Shore Consortium Trunking System, Upper Shore, Maryland - Scanner Frequencies Maryland UMESC
Everything looks right but I must be missing something.
Thanks in advance for the help.