Hoping someone can help - I’m at my wits end.
I have a Uniden BC325P2 for monitoring local fire departments; and feeding into Broadcastify.
setup is a Diamond 130N about 30’ AGL - RG6 down to a grounding block, then into a splitter; feeds a GRE500 for EMS and police, that works perfectly.
other leg of the splitter feeds the Bearcat... it picks up analog fire (150 MHz ranges) great... but the regional system (770 MHz) doesn’t get picked up.
If I disconnect the antenna setup and use a rubber duck, I receive the regional system fine; so I know the programming is ok... but I can’t get the analog fire channels, as they are further away.
The antenna is wideband; and while I know RG6 isn’t ideal, for receive only it shouldn’t be a big deal...
I’m at a loss here - any suggestions?
I have a Uniden BC325P2 for monitoring local fire departments; and feeding into Broadcastify.
setup is a Diamond 130N about 30’ AGL - RG6 down to a grounding block, then into a splitter; feeds a GRE500 for EMS and police, that works perfectly.
other leg of the splitter feeds the Bearcat... it picks up analog fire (150 MHz ranges) great... but the regional system (770 MHz) doesn’t get picked up.
If I disconnect the antenna setup and use a rubber duck, I receive the regional system fine; so I know the programming is ok... but I can’t get the analog fire channels, as they are further away.
The antenna is wideband; and while I know RG6 isn’t ideal, for receive only it shouldn’t be a big deal...
I’m at a loss here - any suggestions?