G5 acting screwy

[19sargeusmc56]

So with this G5 here....when I select Z1, knob 2-6, the durn thing is receiving EVERY TG programmed, instead of just the 1 TG I have assigned.

I don't get it. Zone 3 has 2 knob positions. 2 is select call. That pos is doing the same thing.

Gotta be missing something stupid....

 

[jtwalker]

You have knob position set as TG monitor instead of TG scan. Or you have a wildcard TG in your list of TGs.

Trunking TG-Monitor vs Free Scan

Thoroughly enjoying the new ver 4 PPS! I had been using the Beta Free Scan version since it was released. Thought I'd jump back into the mainstream, especially now since it has Hold and Block (Prior to Beta, I didn't have this). For those of you who are afraid of the learning curve for Vers 4...

forums.radioreference.com

 

[19sargeusmc56]

You have knob position set as TG monitor instead of TG scan. Or you have a wildcard TG in your list of TGs.

Trunking TG-Monitor vs Free Scan

Thoroughly enjoying the new ver 4 PPS! I had been using the Beta Free Scan version since it was released. Thought I'd jump back into the mainstream, especially now since it has Hold and Block (Prior to Beta, I didn't have this). For those of you who are afraid of the learning curve for Vers 4...

forums.radioreference.com

Ok, when I set a knob to TG Scan, I get a prompt telling me at least 1 group should be assigned to the sub-group?

 

[19sargeusmc56]

binding...something....set to none...boom.

 

[hazrat8990]

Try this one. I turned off the voice buffering since it isn't really necessary, and mostly an annoyance. Also, I made a few other edits.

If the selective call knob position doesn't work, you can change the binding feature and wait for tones to test it out.