• To anyone looking to acquire commercial radio programming software:

    Please do not make requests for copies of radio programming software which is sold (or was sold) by the manufacturer for any monetary value. All requests will be deleted and a forum infraction issued. Making a request such as this is attempting to engage in software piracy and this forum cannot be involved or associated with this activity. The same goes for any private transaction via Private Message. Even if you attempt to engage in this activity in PM's we will still enforce the forum rules. Your PM's are not private and the administration has the right to read them if there's a hint to criminal activity.

    If you are having trouble legally obtaining software please state so. We do not want any hurt feelings when your vague post is mistaken for a free request. It is YOUR responsibility to properly word your request.

    To obtain Motorola software see the Sticky in the Motorola forum.

    The various other vendors often permit their dealers to sell the software online (i.e., Kenwood). Please use Google or some other search engine to find a dealer that sells the software. Typically each series or individual radio requires its own software package. Often the Kenwood software is less than $100 so don't be a cheapskate; just purchase it.

    For M/A Com/Harris/GE, etc: there are two software packages that program all current and past radios. One package is for conventional programming and the other for trunked programming. The trunked package is in upwards of $2,500. The conventional package is more reasonable though is still several hundred dollars. The benefit is you do not need multiple versions for each radio (unlike Motorola).

    This is a large and very visible forum. We cannot jeopardize the ability to provide the RadioReference services by allowing this activity to occur. Please respect this.

G5 Paging Issues

Status
Not open for further replies.

bowmanrc

Newbie
Joined
Dec 1, 2018
Messages
1
I have been having issues with the G5 paging over 2-tone analog. I have tried multiple different settings in the 2-tone protocol and several firmwares from Unication which have not helped. I have described the problem below and was wondering if anyone else has had this issue and has any suggestions for fixing?

Medical call should alert with Tone A: 496.8 and Tone B: 1472.9
Fire Call should alert with Tone A: 496.8 and Tone B: 524.6

Another department in the county has a Tone B only of 524.6 and the G5 is alerting for a medical call when this department receives a call. It is also alerting for a medical call when the fire call should alert. I have been in contact with Unication and they can not figure out what is going on. Any suggestions?

Thanks
 

krokus

Member
Premium Subscriber
Joined
Jun 9, 2006
Messages
5,942
Location
Southeastern Michigan
Check the tone detection length, and make sure it is set for two tone only, not single tone.

Sent using Tapatalk
 
Status
Not open for further replies.
Top