KA0KDW
Member
Any trunking scanner that will do P25 phase 1 and Phase 2 would work just fine. And you would only need one to tow frequencies per site for it to work properly. The Uniden 996P2 or Uniden 325P2 would be a great option.
Howell County Question
- Thread starter tvengr
- Start date
huskerswon
Member
Can anyone tell me how to listen to West Plains Fire and SW Howell county EMS?? I have all the codes as I'm a member of this site. I have Unitrunker SDR software and I have SDR Trunk running on windows 11 windows. I have everything running I have check SDR++ and waterfall looks good. I just can't figure out where or how to set up and listen too West Plains Fire, EMS and the Hospital. ANY One out there???
KA0KDW
Member
Last I knew southern Howell EMS was analog and so was west plains PD. I have a private access to those channels to listen anywhere and I hear southern EMS. Don’t think west plains fire is on that private access I use. But I do recall them being analog. Other than that I’m not sure. If I’m not mistaken SDRTrunk is for trucked systems. But not familiar enough with that software to know.
huskerswon
Member
WPPD is on the MOSWIN, West Plains 700, Howell County. I can get them and 911 dispatch. But I never hear WP Fire or SHCA.
KA0KDW
Member
Fire ajd EMS are on analog
KA0KDW
Member
My original post to you should’ve said FD not PD. Sorry for that typo. But the agencies in question are on analog not MoSWIN.
huskerswon
Member
This is what RR has in the data base.
155.955 911 is for Paging/Dispatch/Operations/Interop of Fire/EMS/First Responders (Countywide, 6 Site Simulcast)
I have tuned into this Freq for over 5 hours and have no log of it ever being used. I know Fire was dispatched and several SHCA were out.. nothing..
155.955 911 is for Paging/Dispatch/Operations/Interop of Fire/EMS/First Responders (Countywide, 6 Site Simulcast)
I have tuned into this Freq for over 5 hours and have no log of it ever being used. I know Fire was dispatched and several SHCA were out.. nothing..
huskerswon
Member
I use SDR++ for all Analog traffic.
KA0KDW
Member
If you’re running CTCSSor DCS on the freqhxies id recommend turning that off and seeing if they have changed something.
huskerswon
Member
I am Not. I don't think you can on SDR++ software. It's all analog. I never see any waterfall on these Freq..
