Hello all,
I found this thread (ICOM FR5000 / FR6000 DTMF Decode) that seemed to address my issues but there was only 1 unhelpful response so I'm asking the same question the other guy asked:
I've programmed my FR6000 UHF repeater to put out an active low signal (Active low is more convenient but honestly I don't care) on one of the auxiliary ports on the DB25 connector on the back once it receives a certain DTMF code (1234 for instance), I know the repeater is decoding my DTMF signals because they light up one at a time on the front panel display, but no action is effected. I've even tried the DTMF codes to disable the repeater and re-enable and it doesn't do anything. Does anyone have any ideas here? I can't find any good information in the service manuals and on the interwebs. Looking to not continue pulling my hair out haha. Thanks
I found this thread (ICOM FR5000 / FR6000 DTMF Decode) that seemed to address my issues but there was only 1 unhelpful response so I'm asking the same question the other guy asked:
I've programmed my FR6000 UHF repeater to put out an active low signal (Active low is more convenient but honestly I don't care) on one of the auxiliary ports on the DB25 connector on the back once it receives a certain DTMF code (1234 for instance), I know the repeater is decoding my DTMF signals because they light up one at a time on the front panel display, but no action is effected. I've even tried the DTMF codes to disable the repeater and re-enable and it doesn't do anything. Does anyone have any ideas here? I can't find any good information in the service manuals and on the interwebs. Looking to not continue pulling my hair out haha. Thanks