Morris County TRS P25 rate

Status
Not open for further replies.

08GMC4X4

Member
Joined
Sep 7, 2009
Messages
161
While listening to MIRS TG 33808 there happened to be a lot of activity (foot pursuit). There were many different units responding but they weren't necessarily stepping on each other. I noticed that the transmissions were cutting in and out and noticed my p25 err get as high as 55. I have never seen it this high and it said auto 8 up to auto 12. My question is, does the p25 rate increase with activity on the system (like band with Per say). I have never seen it as high as 55 does this mean i have to change my p25 settings or is this normal? The audio was cutting in and out but I had full bars from the repeater. I even held on 33808 and turned off close call and pri scan. Any input would be appreciates
 

RocketNJ

Member
Joined
Feb 1, 2003
Messages
946
Location
Pequannock, NJ
Try a setting of 7. Where were you and what model scanner/antenna were you using?

Most likely you are not receiving the system strong enough to give you a lower bit error rate.
 

EMTLJB

Member
Joined
Feb 27, 2004
Messages
42
Location
Morris County, NJ
You will not hear multiple units stepping on each other with Morris County's system. It will give the go-ahead to only one user at a time.
 

08GMC4X4

Member
Joined
Sep 7, 2009
Messages
161
"but they weren't necessarily stepping on each other". I was just asking, does the uniden bcd396xt have a harder time decoding p25 as there are more radios on the system? Or is this irrelevant? I tried both the stock antenna and I also tried my 800mhz rs stubby antenna with no change. I was in Madison and was receiving the south simulcast site with full bars on the signal strength indicator .
 
Last edited:

08GMC4X4

Member
Joined
Sep 7, 2009
Messages
161
Wirelessly posted (BlackBerry9000/4.6.0.304 Profile/MIDP-2.0 Configuration/CLDC-1.1 VendorID/102)

A setting of 7 under the p25 adjust mode or p25 adjust level?
 
Status
Not open for further replies.
Top