Pro-163 delay settings

[SCPD]

Does anyone know if you can set the global delay on a conventional bank and or trunked bank to more then 2 seconds?

Thanks
Mike

 

[SCPD]

nobody?

 

[Evert]

I have a Pro-164 which should be the same as the Pro-163 and I don't see any global delay control of any kind (on/off or time).

In Appendix F, Specifications, a 2 second delay time is shown. So apparently that amount of time is hard wired and cannot be changed.

 

[SCPD]

delay does NOT have any effect on trunking systems

 

[kcoleman]

Does anyone know if you can set the global delay on a conventional bank and or trunked bank to more then 2 seconds?

Mike, Below is the only additional information I could find regarding the delay for the 163. I copied this from pages 44-45 of the 163 manual. For conventional looks like 2 sec. is the limit.

"Trunking Delay​

You can set a Talk Group ID delay separately from the channel
delay. When active, the scanner checks the Talk Group ID for the
delay time when a transmission ends.​

To set a Talk Group ID delay:​

1. Press​

​

​

​

FUNC then •/DELAY while you are programming the
Trunk Group ID. “ENTER key saves. 2.0 seconds” appears.
2. Use �� or �� to set ID Delay: None, 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5,
or 4.0 seconds.​

3. Press ENT. "

Regards,
Keith


Sorry Mike the blocks in item 2 should be the "up" & "down" arrows on your keypad.

 

[SCPD]

Thanks for the replys and looking into this for me. Wish it was more then 2 seconds