Sacramento Valley - City of Roseville TRS

[sac-emt]

Using the RR database for Placer County, I have tried to program a Uniden BC796D scanner with the Roseville TRS, but to no avail.

Anyone know if this system is up and running? Cannot detect any data channel chatter, either.

Thank you!

 

[mkewman]

it's up. it's got limited range. where are you located?

 

[sac-emt]

I am in the Arden area of Sacramento.

I could not get a connection to any of the data channels. I might try on my handheld.

Thanks.

Did you catch that crazy pursuit that just occurred in the last half hour (SSD, Air1 & Sac PD) that ended up in a single vehicle crash at Gerber & South Watt. Crazy!!!

 

[Sac916]

I am in the Arden area of Sacramento.

I could not get a connection to any of the data channels. I might try on my handheld.

Thanks.

Did you catch that crazy pursuit that just occurred in the last half hour (SSD, Air1 & Sac PD) that ended up in a single vehicle crash at Gerber & South Watt. Crazy!!!

10851 with stolen plates that crashed into 3 cars...then finally into a pole
10851 broken in half ( maybe 3 or 4 chunks actually )
suspect had a shirt that said somehing to the effect of..

" don't ask me about yesterday, i don't remember and it was probably bad "

 

[RolnCode3]

I can sometimes pick up Roseville from my apartment in Rancho Cordova. It's usually a weak signal, and correct decoding comes and goes, so sometimes it'll find the CC, but not properly decode it, this I can't hear anything. Other times it comes in OK. Depends on the weather and setup, as I seem to be at the limit for my equipment.

It is definitely an active system though. There's traffic on it.

 

[mkewman]

10851 with stolen plates that crashed into 3 cars...then finally into a pole
10851 broken in half ( maybe 3 or 4 chunks actually )
suspect had a shirt that said somehing to the effect of..

" don't ask me about yesterday, i don't remember and it was probably bad "

i bet that bolo was followed by a few kerchunks. hahaha