Yaesu: tx problem ftm 350

[dynamoaust]

i recently programed this radio to use again i have 2mtr repeaters on left and 70 cm on right
70 cm works fine 2mtr reports tx frequency error any ideas as to what is wrong

 

[K9KLC]

i recently programed this radio to use again i have 2mtr repeaters on left and 70 cm on right
70 cm works fine 2mtr reports tx frequency error any ideas as to what is wrong

Sounds like you have the shift set wrong on the 2 meter repeaters.
What frequencies (receive) are wrong?

 

[dynamoaust]

checked the shift all good negative or positive where needed and 600
146.975 negative offset no tone required -----> error tx frequency

 

[BabaYaga60]

checked the shift all good negative or positive where needed and 600
146.975 negative offset no tone required -----> error tx frequency

Is your FTM 350 the UK Bandsplit version ?

 

[K9KLC]

Is your FTM 350 the UK Bandsplit version ?

Good catch, actually where are you located and what is the whole exact model number of the radio? What 2 meter frequencies are working?

 

[mrweather]

OP has his/her location as "newcastle" suggesting the UK.

 

[KevinC]

OP has his/her location as "newcastle" suggesting the UK.

Or Australia.

 

[K9KLC]

OP has his/her location as "newcastle" suggesting the UK.

Or any of about 20 states in the US...

 

[k6cpo]

checked the shift all good negative or positive where needed and 600
146.975 negative offset no tone required -----> error tx frequency

There are several menu items that affect repeater settings. Make sure you have checked all of them. The most important would be Item 2 in the System Group: ARS or Automatic Repeater Shift. This should be ON, allowing the radio's firmware to set the repeater shift , both direction and amount. Also look at Items 3 and 4 in the TX/RX Group, Repeater Shift Direction and Repeater Shift Frequency. Direction should be set to the default OFF and Frequency will depend on the operating band the side of the radio is set to.