UASD rejecting data?

[radio]

I have been trying to load my systems in to the 246T using the UASD full version. However, it is not accepting all the data I put in the configuration. I look to see what percentage this load takes before I hit the write to scanner. It then starts to do its thing. Then it ends stating the memory is full and the percentage is less than what I put in. By looking at the scanner view after that, I see what systems it has not accepted. I have done this several times. I just re-initialized the memory. That did not help. Any suggestions would be appreciated.

 

[Voyager]

I have been trying to load my systems in to the 246T using the UASD full version. However, it is not accepting all the data I put in the configuration. I look to see what percentage this load takes before I hit the write to scanner. It then starts to do its thing. Then it ends stating the memory is full and the percentage is less than what I put in. By looking at the scanner view after that, I see what systems it has not accepted. I have done this several times. I just re-initialized the memory. That did not help. Any suggestions would be appreciated.

Do those systems rejected contain more than 200 channels (TGs)? If so, distribute them into two or more.

Joe M.