Unication G5

[de784]

Has anyone set up the Unication g5 for Sussex Fire dispatch? If so how does it work?

 

[jtwalker]

Yes, works just fine.

 

[Bill24]

P25 works great, however, I was on analog for Bethany Beach FD and sitting behind the Firehouse and my G5 did not alert. I assume they are dispatched over 453.700 (County) but not entirely sure.

 

[Bill24]

Yes, works just fine.

Would you mind looking at my G5 Codeplug? Especially the Tone outs for FD's on analog

 

[jtwalker]

Would you mind looking at my G5 Codeplug? Especially the Tone outs for FD's on analog

Sorry I don’t use tones so I wouldn’t be of any help.

 

[KB3PTP]

For those wondering the 2-Tone Protocol for NCC paging (453.300), use the following settings:

Choose: User Define, then change the following settings:
Tone 1 Duration: 1500 ms
Gap 1 Duration: 0 ms
Tone 2 Duration: 1300 ms
Gap 2 Duration: 0 ms
Long Tone Duration: 8000 ms
Long Tone Gap: 0
Long Tone RX Timeout: 5000 ms
Rx Timeout: 3500 ms
Signaling Activity Timout: 200 ms
Signal Detect Wait Time: 400 ms

You can Find the Fire Tone outs on the Wiki.

 

[dpm797]

Is anyone using the G5 to monitor Fire and EMS talkgroups on the system. If so, what are the Correct WCAN, System Id, and Site Numbers? thank you I have tried setting it up, however I am not having any luck.

 

[maus92]

The info in the RRDB is correct for this system:

State of Delaware P25 Trunking System, Multiple, Delaware

State of Delaware P25 Trunking System Profile

www.radioreference.com

Make sure that you are using hex or decimal values correctly in the G5's programming software. My G5 works perfectly on this system.