Chris0516
Active Member
Now my UBCD325p2 can't communicate with my PC. Any ideas on how to fix this. Would be greatly appreciated.
TIA
TIA
Com Port Closed
- Thread starter Chris0516
- Start date
- Status
Chris0516
Active Member
Nevermind. I found the problem.
MStep
Member
Share please, always share. Others may be having the same issue. Even if you feel it was a beginner's error, or something dumb, I can guarentee that others will be there at some point, so please share the solution. Thanks.
Chris0516
Active Member
Well, The problem started. When I found out, my BCD325p2 did not have an LCN Finder. Despite being able to upgrade it with DMR n' NXDN to the scanner.
So, I had to attempt LCN via the third-party software DSDPlus, and SDRSharp. The software didn't list my scanner correctly.
Instead of my scanner, the BCD325p2(Handheld) being listed. It listed the BCD996p2(Base). Which I don't own. So, Thinking my printer having been listed. That my printer would now be blocked, I changed a setting to the BCD996p2. Now, Proscan will not connect to my scanner. The 996p2 is still listed in the Device Manager under USB Devices.
So, I have to somehow, change it to its' previous setting of my printer.
Chris0516
Active Member
There is another problem(of sorts). I deleted(then rebooted), and re-installed(and rebooted), the driver. But instead of my 325p2(Handheld) showing up in the Device Manager, when I connect the USB cable to the scanner. It shows up in the Device Manager as the 996p2(Base). I don't have the base scanner.
Chris0516
Active Member
I cleared that up. But while my scanner is back in the Device Manager, like it is suppose to be(Port). Proscan isn't seeing it.
Try power cycling the scanner if you haven't done so already.
Chris0516
Active Member
That did the trick, thanks.
- Status
