soarer said:
YEs and one tragic case here in Ashburn...
Brian,
How are you monitering a trunked system on a BC350A???
I can't get my RS 2052 to track them...
Steve
Try this for programming.
Programming for Trunking E2-800 Motorola
1. Press and hold TRUNK until you hear two beeps, all 20 bank numbers should be flashing.
2. Press the number for the bank you want to program, E2-800 should be
on the display and your bank number should be upper left.
3. If your system is Motorola type II then leave E2-800 in place.
4. Press E, Channel 1 of your bank should appear.
5. Using the numbered keys enter you first frequency,
6. Press E
7. Press up/LIMIT, and enter your second frequency,
8. Press E
9. Repeat step 7 and 8 until all frequencies are entered.
10. When completed press TRUNK twice, your bank should be flashing on the
top left.
11. Press SEARCH,
You should now see ----- on the display until the scanner stops on a
conversation. Then the display will show 5 numbers, which is a Talk group ID.
Programming ID’s
1. Press SCAN
2. Press up/LIMIT (----- should be on the display)
3. Navigate up or down until the number 1 appears on the left and a smaller number 1 is in upper left
4. Using the numbered keys, enter the 5 digit ID
5. Press E
6. Press up/LIMIT
7. Repeat steps 4 and 5 until all known ID’s are entered
Note: after programming 10 ID’s, the number 1 appears on the left again and a number 2 appears in the upper left, this is a new ID sub-bank. The scanner has 5 of these 10 ID sub-banks for a total of 50 ID’s per scan bank
