red8
Member
If I were program the just the control channels to LWIN on my TRX-1, would they receive any voice traffic?
Monitoring LWIN control channels
- Thread starter red8
- Start date
TRX-1: - control channels only ??
When programming a P25 Phase I Moto type system can I just enter the control channels or do I enter all the freqs listed in the RR database for that system? System is SF bay area and called EBRCS.
This post seems to best describe the TRX-1 when it comes to CC only programing (or voice channel only programming?) for P25 systems. Going through the whole thread left me just as confused as when I started. I guess I have too much Uniden in my brain to comprehend Whistler radios.
Good news is LWIN seems to stay on the prime or alternate cc most of the time. So frequency changes seem to be rare outside of these channels (however I have seen a north site CC switch between two cc's and a voice channel in less than a minute but this was a "once in a lifetime event")
If you have programming software, give it a try and let us know! I would advise treating cc's as a group to avoid the always possible switch (meaning program all CC's at all times).
red8
Member
All I have is the E-Z scan for the Trx-1.TRX-1: - control channels only ??
When programming a P25 Phase I Moto type system can I just enter the control channels or do I enter all the freqs listed in the RR database for that system? System is SF bay area and called EBRCS.forums.radioreference.com
This post seems to best describe the TRX-1 when it comes to CC only programing (or voice channel only programming?) for P25 systems. Going through the whole thread left me just as confused as when I started. I guess I have too much Uniden in my brain to comprehend Whistler radios.
Good news is LWIN seems to stay on the prime or alternate cc most of the time. So frequency changes seem to be rare outside of these channels (however I have seen a north site CC switch between two cc's and a voice channel in less than a minute but this was a "once in a lifetime event")
If you have programming software, give it a try and let us know! I would advise treating cc's as a group to avoid the always possible switch (meaning program all CC's at all times).
Similar threads
