SDR# + Configuration Problem

Status
Not open for further replies.

OKCarl

Member
Joined
Jul 15, 2014
Messages
10
Location
Arlington Heights, Illinois
I am trying to run SDR# version 1.0.0.1313 on a Hewlett Packard laptop with four gigabytes of ram. My dongle is a NooElec R820T SDR & DVB-T NESDR Mini (RTL 2832U).

I can see the waterfall. I can see peaks. But all I hear is low frequency static punctuated by squeals and squeaks. When I click on the knobby 'Configure' button I get an error message reading- "Will be implemented later." What am I doing wrong? I suspect I am using the wrong configuation file or I put the confiuration file in the wrong folder. One of my config files (SDRSharp.exe) weighs 7 kilobytes (actually 6.21 kilobytes) the other weighs in at 7 kilobytes (actually 6.14 kilobytes).

So far, I've tried swapping the Config files in and out of the SDR# folder. This effort makes no difference. Advice? Suggestions?
 
Status
Not open for further replies.
Top