ht1250

Hello everyone. I'm having a problem programming my HT1250. I just bought an aftermarket ribless cable for it on ebay and am trying to program it in CPS. I have all the drivers installed for the cable and have chosen the right COM port in Read Device in CPS. Once I pressed OK, a message came up...

Hi, I have a general question about the 2 tone decoder for the HT1250. I have the radio programmed to alert when my station is activated for an emergency. When the tones are set off the radio alerts. My question is when the radio alerts it actually cuts off the first 5-6 seconds of the...

Hi, I dont know if this would exactly be the place to ask... but i have an HT1000 VHF radio, and a HT1250 UHF radio. i noticed the signal is a lot harder to pick up on VHF than UHF. I can hear UHF much more clearer than any of the fire departments or pd's on VHF. is VHF harder to receive or...

Hi all, First let me start by saying that if this question has already been asked/answered I apologize. I looked through the forums and searched and didn't get a full answer. I have a HT1250 VHF, Software Version # R05.12.02. I'm looking to purchase a UHF HT1250, Band Split of 403-470 Model #...

Hello everyone, I have a Motorola HT1250LS+ Model #AAH25RDH9DP5AN. I'm having an issue while scanning, it won't pick any transmissions up while the scan option is enabled. but when I turn scan off it will pick-up on whichever channel is selected. I am familiar with the CPS I'm just unsure what...

Hello all I recently purchased a HT1250 and have it set up the way I like. I ordered a speaker mic for it from ebay and it works, but I get the audio from both the speaker mic's speaker and the HT's speaker. Since the accessories are supposedly interchangeable with the Moto GP338 I hooked the...

When my page goes on on my ht1250 it plays the alert sound but doesn't play the pager after it just goes back to silent. does anyone know how to have a call received button? so when you hit it the tone stops and the page plays

Hello Anybody here have any experience with tuning down the power wattage for the transmitter so one can "legally" use an HT1250 on the multi use radio channels. I'm aware the radio does not meet the exact MURS specifics but it seems to be that if the radio can be tuned to meet the standards...

Is there a place to sample the Alert tone tags. I have been searching everywhere and i cannot find any sound clips of the sounds. There are 8 of them standard through alert 7. Any help would be greatly appreciated,

This may be stupid but i recently had my 1250 programmed for use at work, all of the channels in the zones work except for one of them. 153.62000 is the frequency for this channel 431 DPL, i tried to use it this morning at work and was able to transmit and my dispatch, and they could hear me...

I was recently given two Motorola vhf 1250 radios by a former coworker who accepted a new job out of the country. one yellow and one black, but they are both 1250s. While attempting to program the yellow radio, I kept experiencing problems because the P2 and button above p1 (up one level) are...

i was looking at a 6 bank impres charger for ht1250 radios. right now we have a standard charger with batteries that dont hold charge any longer. Seen the impres charger and batteries like to switch to li-ion batteries. is the Impres worth it? just trying to get some feed back and looking for...

The accessory pins on the side of my radio are corroded and wore off...not allowing me to program it. Does anyone know the part number for just the pin area? Do I need a whole new board? Thanks!

Hi! I recently purchased two VHF (136 - 174 MHz) HT1250s on eBay (I know, I know :roll:) that I suspect might both have busted PAs; what luck! Unfortunately, I don't have a power meter or the right equipment for that matter to confirm my suspicion, but a friend and I tested the pair out and...

Hey- Quick question. Does anyone know if the Motorola HT1250 can have Alpha characters in the radio's transmitted ID and if so, how many alphanumeric characters is the ID limited to? For example, our radios are currently IDed as: 331A 331B 331C 331D 331E 331F Is it possible to rename them...

Hi everyone! I've got a problem with programming scanning in my HT1250LS+. I've created two conventional zones - the first one consists of 2 channel, the second one- of14. I also created 2 scan lists which also have 2 and 14 personalities. What I wanted is to be able to scan all the channels of...

Hi everyone! I am brand new to this site so I apologize if this is not appropriate. I have two motorola refurb. ht1000 2 ch UHF portables with the appropriate belt clips, dust covers, antennas, new batteries (charged once), chargers, and one speaker mic, and a mint motorola oem leather carry...

Anybody know where I could get a blue GP380/HT1250 in close to new condition or a blue casing/refurb kit for one? (At a reasonable price Ex: under $300) As seen on page 4 of this document, Blue Radio Shown in This PDF Doc Example of yellow refurb kit: 200479923151 Oh, PS: Is there any other...

I have been using a motorola XTS for the past several years and really enjoyed it. It was the XTS 3000 model 2. When I pushed the PTT button to transmit, a loud chirp would occur. It sounds like 3 very rapid beeps. I really liked this feature and was wondering if the HT 1250 can be programmed to...

Hi all, i recently came across a copy of cps for my ht1250 and i have some questions. It seems that i have figured out the basics. What i dont understand is the quik call and mdc stuff. How does it work? And whatis it for? How could it be utilized in a small ambulance service? My other question...