sdrtrunk

I read where the latest beta of sdrtrunk added support for the RSPduo, so I got the radio out of the drawer and hooked it up to my 2m/70cm ham antenna. Got the API installed on Windows 11 and finally understood how to get sdrtrunk to talk to it. I began by manually adding 6 active VHF analog FM...

Good evening everyone, I have recently purchased an RTL-SDR and paired it with SDRTrunk to scan the Alaska Land Mobile Radio (ALMR) system in the Fairbanks North Star Borough. I am uploading via a Calls Ingest here as well as a 'regular' audio feed here. It is important to note, both feeds are...

Newbie to SDRTrunk. I've got the Radioreference database importing info into SDRTRunk just fine but it only shows County, State and Federal agency tabs. There's no CITY agencies? So I'm not getting local city PD freqs or city fire because they are city agencies. They are obviously on the...

I just hooked up my sdr and I imported from rr my county, however after listening for several hours I noticed nobody is talking. I played around with it earlier changing the control freq and I was picking up neighboring counties traffic. I will post a few screenshots as well. I know my city is...

I just started streaming to the call ingest today, anode 2830. I noticed when listening to my feed that sometimes I may here something on SDRtrunk but not on my feed, like I may here a unit call for dispatch, hear dispatch on my SDRtrunk but not hear it on my stream. I also noticed this when...

I recently bought a new desk for my radio room to replace the previous countertop & drawers. When I was searching for the new desk, I had some requirements in mind... I needed it to be sit/stand, L shaped or wraparound, and be humongous enough to fit my monitors, radios, both PCs and...

Hello everyone, I was wondering if anybody would know why sometimes when I'm using my 2 RTL-SDRs to listen to a P25 system it will pick up all transmissions, but then randomly it will miss one. Does anyone know how to fix this?

Hello, I feed to BCFY feeds, 2 calls nodes, and 2 rdio scanner servers. All of a sudden, and since the lost recent update, everything but the calls node's work. Once a call goes in line for either, it immeidaltey switches from "connected" to "temporary broadcast error) and no calls go through...

I just got a Nooelec NESDR SMArt v5 dongle and trying to figure it all out so I apologize in advance for the newb question. I got SDRTrunk up and running with P25 for my area here in Arkansas, but I am not seeing the Alias listed except for State agencies in the scan mode. I have checked my...

Hello, i set up a local rdio scanner server thats connected to sdrtrunk so i can roll the tapes back if need be. ive been editing the talkgroups and organizing everything, and have made some serious progress. however i am having an issue that just popped up out of nowhere. all of a sudden, when...

Hello, I recently started a BCFY feed, and I use BUTT to stream it. I noticed in the settings under primary audio device it has a dropdown list to select the audio source, then to the right of that it says "left" and "right". Left has 1 selected and right has 2 selected. The channel mode is set...

Hello, after I figured out how to use Sdrtrunk and became more educated on the matter, I decided to create 2 calls nodes (one for each site), and 1 feed to fill a void in my areas BCFY feeds. Everything has been smooth sailing, but recently ive been running into problems after playing around...

Hello. I'm new to scanning and newer to SDRs, but I do actually have 75% of it figured out. I know how to use sdr++, pdw, sdrtrunk, satsagen, dsd+, and all that stuff. After I figured out sdrtrunk, I discovered it was comical Ly easy to create a broadcastify calls node and a feed. So I did both...

All 3 of my SDR Dongles randomly started producing the error below. They were all working yesterday and then this morning all 3 were displaying the same exact fault. I've tried everything from resetting the computer to unplugging and plugging the SDR and downloading SDRTrunk Alpha 6. I am using...

I have been using SDRTrunk with Trunking recorder for a while now to monitor/record my local P25 system with a ton of success (outside crashes in SDRTrunk due to it running on an underpowered computer). I highly recommend this setup for anyone who prefers archival/recall of calls versus live...

Hi I am using SDRTrunk to monitor and stream 3 freqs 1 is P25 1 is DMR and one is analog. I followed the directions for setting it up and it is showing connected but its been running for about 14 hours and nothing is being uploaded/ streamed now I do have another program called Radio Feed which...

I recently switched my feed app over to using SDRTrunk. (sdr-trunk-windows-x86_64-v0.5.0-beta2) I feed one P25 simulcast site to "Calls Ingest" and three "Audio Feeds" from the same site. One of the Audio Feeds is quite busy and routinely has calls stacked in the queue, which I understand causes...

I've recently gotten an RTL-SDR v3 dongle and have been trying to listen around and had a few questions. Getting right to the point, I'm trying to use SDR-Trunk to listen to UCA but I'm unable to get any data from the control channels an I don't quite know why. To my knowledge I should have...

I am a feed provider streaming a P25 simulcast using a conventional scanner. I have been learning to use SDRTrunk and find it far superior to my Uniden BCD536HP. I have SDRTrunk (v0.5.0-alpha6) configured with two RTL-SDR dongles running on a quad core with Windows 10 I have my P25 system...

Hello all. I've recently had time to get back into SDR after a few years and I'm having some issues with my new tuners and software. The SDR setup consists of a Windows 8.1 workstation with two tuners, the first a Nooelec NESDR v4 RTL-SDR (820T) and another NESDR XTR (E1000). The first time I...