I seem to be having an issue programming in a trunking system on an XG-100P.
The trunking system i am attemting to program in is the Alamo Area Regional Radio System (AARRS) In San Antonio Texas
I am trying to program in the Northeast Simulcast system and I cannot for the life of me get it to lock onto CCs.
I have verified the correct trunk frequencies are in. there are 2 possible issues that i can think of.
one
under the IDEN sets the IDs only call for 1 and 9 to be populated. So was i correct in programming 1 for 851.01250 -45 12.5khz FDMA full and
9 851.01250 -45 12.5khz TDMA
two
i noticed when putting in the system ID the system calls for 0D2 so when i enter that sysid and save it it saves at d2 without the zero. is this where my problem lies?
my NAC, and site ID are correct.
Any help would be greatly appreciated.
I have attached the screen shots of my configuration for NAS.
The trunking system i am attemting to program in is the Alamo Area Regional Radio System (AARRS) In San Antonio Texas
I am trying to program in the Northeast Simulcast system and I cannot for the life of me get it to lock onto CCs.
I have verified the correct trunk frequencies are in. there are 2 possible issues that i can think of.
one
under the IDEN sets the IDs only call for 1 and 9 to be populated. So was i correct in programming 1 for 851.01250 -45 12.5khz FDMA full and
9 851.01250 -45 12.5khz TDMA
two
i noticed when putting in the system ID the system calls for 0D2 so when i enter that sysid and save it it saves at d2 without the zero. is this where my problem lies?
my NAC, and site ID are correct.
Any help would be greatly appreciated.
I have attached the screen shots of my configuration for NAS.
